Quick Installation - Allied Telesis AT-MR420TR Installation Manual

Installation

Quick Installation

1. Carefully remove the AT-MR420TR/AT-MR820TR Micro
Repeaters from their packaging materials. Keep the packing
materials until you have successfully installed the product.
2. Place them in a location with adequate ventilation and power
receptacles.
3. Apply power by plugging in the AC cord and ensure that the
POWER LED on the front panel is illuminated.
4. If you are connecting to a backbone network, prepare either the
AUI or BNC cable for attachment.
5. Attach your 10Base-T STP/UTP cables, with RJ45 connectors to
the 10Base-T ports. If the UPLINK port is not used for cascading,
you may connect a standard 10Base-T cable to port 4/8.
6. If the AT-MR420TR/AT-MR820TR Micro Repeaters are to be
connected to an external transceiver, attach a transceiver to the
15-pin AUI connector on the back panel. Ensure that the external
transceiver has its Signal Quality Error (SQE)/Heartbeat Test
function disabled. When power is applied to the AT-MR420TR/
AT-MR820TR Micro Repeaters, the external transceiver should
also have power.
Because of the default switch positions, you do not have to
changes any switches.
8
Note