Operating Instruction - Challenge MPS3-08CRN1-QB6G1 Instruction Manual

OPERATING INSTRUCTIONS
8 8
v
Power save mode
When the room temperature is lower than
the setting temperature for 30 minutes,
the unit will switch itself to power save mode.
The compressor and fan motor will stop
and the power save mode indicator will
illuminates. When the room temperature
is increasing over the setting temperature,
the unit will switch back to normal mode to
operate. The indicator will go off and both
compressor and fan will turn on again.

Operating Instruction

COOL operation
- Continue to pre ss the "MODE" button until the
"COOL" indicator light comes on.
- Continue to pre ss the ADJUST buttons " " or
" to select your desired room temperature. The
"
temperature can be set within a range of
- Continue to pre ss the "FAN" button to choose the
fan speed.
DRY operation
- Press the "MODE" button until the E" butt
"DRY" indicator light comes on.
- Under this mode, you cannot select a
fan speed or adjust the temperature.
- Keep windows and doors closed for
the best dehumidifying effect.
- Do not put the hose to window.
AUTO operation
- Continue to press "Mode to select the
"Auto mode. It " will automatically select
cooling, fan only operation depending
on what temperature you have selected
and the room temperature.
- The air conditioner will control room
temperature automatically round the
temperature point set by you.
- Under AUTO mode, you can not select
the fan speed.
NOTE: Under AUTO mode, both the
AUTO mode and the actual operation
mode indicator lights illuminate.
O O
17 C-30 C
"
9
FAN operation
- Continue to press "MODE" butt on until
"FAN " indicator light comes on.
- Continue to press "FAN" but ton to
choose the fan speed. The temperature
cannot be adjusted.
- Do not put the hose to window .
TIMER operation
- When the unit is on, first press the
Timer button, the TIMER OFF
indicator light illuminates. It indi-
cates the Auto Stop program is
initiated.Press the Timer button
again,the TIMER ON
illuminates. It indcates the Auto
Start program is initiated.
- When the unit is off, first press the
Timer button, the TIMER ON indic-
ator light illuminates. It indicates
the Auto Start program is initiated.
When the unit.Press the Timer button
again,the TIMER OFF indicator light
illuminates. It indcates the Auto
Stop program is initiated.
- Press or hold the UP or DOWN
button to change the Auto time by
0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24
hours. The control will count down
the time remaining until start.
- The selected time will register in 5
seconds and the system will autom-
atically revert back to display the
previous temperature setting.
- Turning the unit ON or OFF at any
time or adjusting the timer setting
to 0.0 will cancel the Auto Start/
Stop timed program.
- When the malfunction (E1 or E2)
occurs, the Auto Start/Stop timed
program will also be cancelled.
indicator light