Cisco SG350XG-2F10 Quick Start Manual page 8

Make sure that any configuration changes made are saved
C
AUTION
before exiting.
You are now ready to configure the switch. Refer to the Cisco
350XG Series 10G Stackable Managed Switches Command
Line Interface Reference Guide for further information.
If you are not using DHCP on your network, set the IP address type
N
OTE
on the switch to Static and change the static IP address and subnet
mask to match your network topology. Failure to do so may result in
multiple switches using the same factory default IP address of
192.168.1.254.
Stacking the Cisco 350XG Switches
Before configuring the switches as a stack, refer to the Cisco 350XG
Series 10G Stackable Managed Switches Administration Guide for
additional details. Refer to the front panel graphics in
Switches Features
modules.
By default the ports on a switch function as regular Ethernet ports except if
you configure them to do stacking. You cannot mix the stack speeds
between the switches or ports.
Stack ports must be either configured with the same port
W
ARNING
speed or have the same speed capability on the module or
cable plug in. If the port speed is configured as auto, then the
module plugged into these two ports will need to have the
same speed capability, otherwise the switch will not be able to
form as a stack with multiple units.
A stack can have up to four 350XG series switches in it. Any port of the
switch can be used for stacking. The switch can only be stacked with the
Cisco 350 series switches without Mesh topology.
The switches in the same stack are connected together through their stack
ports. Depending on the type of stack ports and the desired speed, you
may need regular Cat6A or better Ethernet cables and/or Cisco approved
modules or cables for the Cisco 350XG series switches.
8
to help with the stack port descriptions and supported
Cisco 350XG Series 1OG Stackable Switches Quick Start Guide
Cisco 350XG