Roland CX-500 User Manual page 37

Calling Up
1
Press the [PRESET] key.
2
Use the [ ] and [ ] keys to select the preset number
you want to call up. The parameters set to the selected
preset number appear on the display. You can use the
[ ] and [ ] keys to confirm the set parameters.
3
Press the [ENTER] key. The preset number you
selected is called up and the display changes as shown
at right.
Deleting Settings
You can delete the stored settings for cutting conditions, returning them to their factory defaults. Please note that all preset numbers
from 1 to 8 are deleted.
1
Press the [MENU] key to enter the menu mode.
2
Press the [ ] key several times until the screen shown
at right appears.
3
Press the [ ] key to move to the [FACTORY
DEFAULT] menu.
4
Press the [ ] key to move to the setting screen, then
use the [ ] and [ ] keys to select [PRESET].
5
Press the [ ] key.
6
Press the [ENTER] key.
The user settings stored at preset numbers 1 through 8
are deleted and the factory-default settings are
restored.
7
Press the [ ] key to exit the menu mode.
PRESET1
50-0.250-50
Speed - Offset - Force
Press [ ].
PRESET1
NORMAL-50
Press [ ].
Quality - Up Speed
PRESET1
0.250mm
SUB MENU
FACTORY DEFAULT
PRESET
FACTORY DEFAULT
PRESET PRESET
ARE YOU SURE?
NO:
50cm/s
50gf
YES:
37