EarthQuaker Devices Pyramids Operation Manual page 5

Hide thumbs Also See for Pyramids:

In Live mode, the Activate LED is always green. When using a saved preset, the Activate LED

is yellow, and will change to red when a preset setting is changed. When saving a change to

a preset or writing an entirely new preset, the Activate LED will flash and turn yellow once the

change/preset has been saved. The Tap/Trigger LED is white and will flash in tempo regardless

if the tempo is set via the Rate control or the Tap/Trigger Footswitch. The Tap/Trigger LED is not

used in both Trigger up and down modes and will remain dark.

• Current Draw: 425mA

• For best results, please use the included 9v center-negative 1-amp DC power supply.

• To use with multiple output transformer-balanced isolated pedal-specific power supplies,

Pyramids' may be powered from two outlets combined using a current-doubling cable. DO NOT

USE A VOLTAGE-DOUBLING CABLE BECAUSE THAT WILL SEND 18V TO PYRAMIDS

AND FRY IT LIKE AN OVEREASY EGG AT A GREAZY SPOON DINER.

• 24-bit 96kHz A/D & D/A converters

• S/N Ratio: 115dB typical

• Input Impedance: 1M Ohm

• Output Impedance: 100 Ohm

• All analog dry signal path

• All digital wet signal path with

20Hz – 20kHz frequency response

This Device has a limited lifetime warranty. If it breaks, we will fix it. Should you encounter any

issues, please email info@earthquakerdevices.com.

<<< LED Behavior >>>

<<< Power Requirements >>>

<<< Tech Specs >>>

<<< Warranty >>>

www.earthquakerdevices.com

• PCBs populated by a combination of artificial

and human intelligence in the Akron, Ohio

of America.

• Each and every Pyramids is completely

assembled, wired, and tested by total human

beans in the Great Sphinx of Akron, Ohio,

which, coincidentally, looks exactly like the

cover of Iron Maiden's Powerslave.