Safety Instructions - Ametek T-620 Operation Manuals

Safety Instructions

„ „ „ „ „
SaFeTy InSTrucTIonS
Please follow the instructions and procedures described in this manual. They are designed to help you get the most out of your pressure system and to avoid
any personal injuries and/or damage to the system.
Please notice the pump comes in 2 different pressure ranges. Therefore it is very important to check the version of the pump to avoid over-pressurizing the
indicator.
Note:
The product liability only applies if the pressure system is subject to a manufacturing defect. This liability becomes void if the user fails to follow the
maintenance instructions set out in this manual or uses unauthorized spare parts.
When using this pump:
•
Avoid knocking, bumping, or dropping the pump. This can cause permanent damage.
•
The pump must not be used for any purposes other than those described in this manual, or for any application other than precision pressure calibration tasks.
•
The pump should only be used by TRAINED PERSONNEL.
•
None of our calibration systems are cleaned or prepared for OXYGEN MEDIUMS. DO NOT USE our systems for this purpose.
•
Do not disconnect any parts from the system when pressurized.
!
Warning: do not connect any external pressure source to this system. This system is designed to test pressure measuring devices connected to the
manifold only. Pressure from an external source can result in explosion of the liquid reservoir and possible personal injuries.
Safety Instructions 3

T-600 Series Pump Operation Manual