Table of Contents
Advertisement
Normal Measurement Mode
1.
Slide the POWER switch to the ON position.
2.
Zero the meter before each measurement.
3.
Touch the adapter to the object being measured in a straight line. Refer to Fig.1.
4.
Begin measurement by applying force (Push or Pull). Read the LCD display.
5.
After completing the measurement, the display will indicate "0.00" if the position and angle of
the Force Gauge have not changed.
6.
If the position or angle of the Force Gauge changes during a measurement, the display may
show one of the following:
a) The display over-ranges because the initial force of the transducer decreases due to a
change in the position or angle of the Gauge after measurement.
b) The display indicates any value such as "12", "25", etc. This occurs because the initial
force of the transducer increases due to a change in the position or angle of the Gauge
after measurement.
Note: Be sure to press "ZERO" before taking any new measurements.
Mounting
For best results, mount the Digital Force Gauge to a test stand. Mounting holes are provided on the
rear of the meter.
www.ponpe.com
4
475040-475044-EU-EN v2.6 4/14
contact:
sale@ponpe.com
Advertisement
Table of Contents
Need help?
Do you have a question about the 475040 and is the answer not in the manual?
Questions and answers