Table of Contents
Advertisement
5. INTRODUCTION
5.1
DESCRIPTION AND APPLICATION OF THE CO2 DOMINATOR
The CO2 Dominator is intended to electronically blow white smoke plumes of CO
leaves the cylinder through the CO2 Dominator's secured high-pressure hoses, it
soon as the CO
2
converts into gas. This formation of gas is accompanied by a strong hissing sound and a solid white
plume of smoke will be visible. The length of this plume is on average 8 metres. This depends on the
air humidity: in case of a high degree of air humidity, the smoke plume will be larger and in case of a
low degree of air humidity it will be smaller.
The CO2 Dominator must be connected to a carbon dioxide (CO
Any use other than that described above excludes your supplier from any liability.
The CO2 Dominator has been designed and constructed in such a manner that it can be used safely.
This applies to the application, the circumstances and the regulations as described in this
documentation. Reading this documentation and the following instructions are therefore necessary for
everyone who is authorised to work with the CO2 Dominator.
5.2
NECESSARY ACCESSORIES
De volgende onderdelen horen bij de CO2 Dominator:
Manual
High pressure hose 3/4
Table 5.1
MFX0308 – Power cable
MFX1154 – Distribution block
from a distance. As
2
) cylinder with dip pipe.
2
4 CO2 Cylinders (with dip pipe)
High pressure hose 3/8
Version 1.0
Page 6
Advertisement
Table of Contents
