Installation - MAGIC FX MFX1150 Manual

10. INSTALLATION

For installing the CO2 Dominator work in the following manner:
1.
2.
CAUTION:
The machine can be damaged if you do not follow the procedures
carefully.
DANGER WARNING:
The MAGICFX® CO2 Dominator may only be installed by adults and
authorised persons.
DANGER WARNING:
MAGIC FX is not liable for working with CO2 gas and CO2 bottles or for
the correct use thereof.
Exclusively use approved CO2 bottles (liquid carbon dioxide with dip
pipe) and consult your gas supplier about the installation, instructions,
guidelines and regulations for the safe use of the CO2 bottles.
Place the CO2 Dominator on a stable and
even surface
Make sure that there is always a space of 3
metres around the CO2 Dominator which is
free of people.
Check if the on/off switch is in the 'off'
position and then connect the power
cable. The CO2 Dominator runs on 230V~
50/60Hz.
You will need a powerCON plug to
provide the CO2 Dominator with power.
The CO2 Dominator is also equipped
with a powerCON 'loop cable' connector.
By using a powerCON loop cable you
can connect several CO2 Dominators to
the same energy source.
Version 1.0
Page 12