Table of Contents
Advertisement
User documentation MAGICFX® CO2 Dominator
9.
1
0.
1
1.
Page 15
Turn on the machine by pushing the
switch of the CO2 Dominator in the 'on'
positon.
After the CO2 Dominator has been fully
connected the CO2 Dominator can be
installed.
During installation, make sure that you use
free channels on the DMX controller and
that these channels are in the safe mode.
The safe mode means that during the
installation of the CO2 Dominator the 0-
values of a channel are set. Consult the
manual of the DMX controller for the set-up.
Push the 'MODE' button to start the set-
up of the CO2 Dominator.
The display will now change to the
screen pictured on the left.
You will see the address behind Safety flash
on and off. This is the address which can be
used for releasing the machine.
Change to the required address by
pushing the▲ or ▼ button. Then push
the MODE button to confirm your choice.
When you use several machines it is
advisable to use the same 'Safety' channel
for each CO2 Dominator.
Advertisement
Table of Contents
