Table of Contents
Advertisement
User documentation MAGICFX® CO2 Dominator
11. USAGE
For using the CO2 Dominator take the following steps:
1.
2.
Page 17
TIP:
Gives you suggestions and advice regarding easier or more
convenient ways to carry out certain tasks.
CAUTION:
The machine can be damaged, if you do not follow these procedures
carefully.
DANGER WARNING:
The MAGICFX® CO2 Dominator may only be installed by adults and
authorised persons.
The CO2 Dominator may only be operated if all parts are completely
and correctly installed/connected.
After the set-up of the CO2 Dominator
and the correct addresses you are ready
to use the machine.
To get the CO2 Dominator out of the safe
mode, the 'safety' channel on the CO2
Dominator must be set between 40% and
60%.
The LED light on the back of the CO2
Dominator now starts to flash on and off.
To activate the CO2 Dominator and to
have a CO2 smoke plume blow from the
machine, you press the flash button of
the 'fire' channel on the DMX controller.
Before starting to blow CO2 always make
sure that nobody is present within the zone
of the CO2 Dominator. Additionally, always
ensure you have a clear vision of the CO2
Dominator during the effect. For the correct
use of the DMX controller you can consult
the manual of the machine.
Advertisement
Table of Contents
