Advanced Function Of Vcr Section; Stereo Recording And Playback; Second Audio Program (Sap) - Disney DVD2100-C User Manual

Advanced function of VCR section

Stereo recording and playback

The VHS Hi-Fi audio system permits high fidelity record-
ing of MTS STEREO TV broadcasts.
When a MTS STEREO broad-
cast is received, the word STE-
REO will appear on the screen
and the program can be viewed
or recorded in stereo.
The Hi-Fi STEREO recording procedure is the same as for
normal recordings.
NOTE:
When using a CABLE system, stereo TV programs may be
transmitted over a mono cable channel. In this case the word
"STEREO" will not appear and the sound will be in mono.
Output selection
When viewing an MTS STEREO TV program, or playing a
prerecorded VHS Hi-Fi STEREO videotape, press Audio
Select to select how the audio will be heard through the
speakers. Normally set to the Hi-Fi STEREO position, this
button can be set to the MONO position if the stereo
broadcast or videotape audio is of poor quality. The "R" and
"L" positions allow the audio from the Right or Left Hi-Fi
channel to be heard over both TV speakers. This button has
no effect when viewing a MONO videotape or TV program.
Each time when you press the button, output selection
display appears on the screen for several seconds. Refer to
the chart below.
OUTPUT
SELECTION
STEREO
L ch
R ch
MONO
22
STEREO
SOUND HEARD ON BOTH
SPEAKERS
STEREO
LEFT CHANNEL AUDIO
RIGHT CHANNEL AUDIO
MONO

Second Audio Program (SAP)

Your VCR is fitted with a SAP broadcast system which
enables you to switch to a second audio program when
viewing a selected channel.
This function applies only when the program is broad-
cast in multi-languages through the SAP broadcast
system.
1
Press VCR Menu. Then press Set + or – to select "SAP".
2
Then press Enter to select "ON".
3
Then press VCR Menu until the menu screen is cleared.
Listening to SAP
When the VCR is turned on or a channel selection is made,
make certain the letters "SAP" appear on the screen. This
means that the "Second Audio Program" broadcasting is
available.
NOTES:
When playing back a tape that is not recorded in Hi-Fi stereo
•
mode, the audio will automatically be monaural.
When listening to a VHS Hi-Fi video tape or MTS broadcast
•
through the VHF/UHF jack (Audio/Video cord not connected),
the sound will be monaural.