Panasonic HG-C1030 Instruction Manual

Micro Laser Distance Sensor (CMOS)
Thank you very much for purchasing Panasonic products. Please read this
Instruction Manual carefully and thoroughly for the correct and optimum
use of this product. Kindly keep this manual in a convenient place for quick
reference.
WARNING
● This product is intended to detect objects. Do not use it to carry out
safety control functions to prevent accidents.
● Never use this product as a sensing device for personnel protection.
● Do not look into the beam directly during operation.
1
CE marking
This product complies with the following standards and
regulations.
● For the EU: EMC Directive 2014/30/EU
Contact for CE:
Panasonic Marketing Europe GmbH
Panasonic Testing Center
Winsbergring 15, 22525 Hamburg, Germany
2

Confirmation of packed content

● Sensor
● Laser warning label (JIS Standards, GB Standard) 1 set each
● FDA certification label
● Instruction Manual (Japanese, English)
3

Safe use of laser product

In order to prevent accidents caused by laser products and to protect the
users, IEC, JIS and FDA established the following standards:
IEC: IEC 60825-1-2007 (EN 60825-1-2007)
JIS: JIS C 6802-2011
FDA: PART 1040 (Performance standards for light-emitting products)
These standards classify laser products according to their level of hazard
and provide safety measures for the respective classes.
Warning label and position
LASER RADIATION
(MAXIMUM OUTPUT) 1mW
(PULSE DURATION) 5ms max.
CLASS2 LASER PRODUCT
LASER APERTURE
An English warning label is attached to this product.
4

Part description

1
2
3
4
5
INSTRUCTION MANUAL
HG-C Series
ME-HGC1000V3EN 05/2017
1 pc.
1 pc.
1 pc. per language
DO NOT STARE
INTO BEAM
(WAVELENGTH) 655nm
(IEC60825-1 2007)
9
8
6
7
No.
1
2
3
4
5
6
7
8
9
5

Mounting

When mounting this product, use M3 screws (prepare separately).
Use a tightening torque of 0.5 N m for mounting.
M3 screws
Mounting direction
● When performing measurements of moving objects with excessively
different materials and colors, mount the product in the following direc-
tions to minimize measurement errors.
● When performing measurements of rotating objects, mount the prod-
uct as follows. The effect of up/down deflection and position deviation
can be minimized by mounting the sensor in the correct direction.
● When there is a step in the moving object, mount the product as fol-
lows. The effect of reflection deviation by the edges of the steps can
be minimized by mounting the sensor in the correct direction.
1
Item
Zero set indicator (Yellow)
Teaching indicator (Yellow)
Output operation indicator (Orange)
Laser emission indicator (Green)
TEACH key
UP key
DOWN key
Digital indicator (Red)
PRO indicator (Yellow)
Mounting hole dimensions
18mm