VTech VM320 Quick Start Manual page 2

Basic operation - Parent unit
Adjust speaker volume Zoom
Press to zoom in or out.
Press VOL / VOL to adjust your parent unit
speaker volume. It determines the volume of sound
transmitted from your baby units.
Night vision
The baby unit has infrared LEDs that allow you to
see your baby at night or in a dark room. When
the baby unit detects low light levels, the infrared
LEDs turn on automatically. The images from the
baby unit are in black and white, and unit are in black and white, and
on screen.
NOTES
• It is normal if you see a short white glare on your
parent unit screen as the baby unit is adapting to the
dark environment.
• When the infrared LEDs are on, the images are in
black and white. This is normal.
TIP
• Depending on the surroundings and other
interfering factors, like lightings, objects, colors and
backgrounds, the display resolution may vary. Adjust
the baby unit's angle, or place the baby unit at a
higher level to prevent glare and blurry display.
Mount the baby monitor (optional)
You will need to purchase the following
items separately to mount your baby unit:
2 screws
2 anchors
NOTES
• Check for reception strength and
camera angle before drilling the holes.
Use a pencil to mark two holes in
parallel. Make sure they are the same
distance apart as the wall mount
holes on the baby unit.
Talk to your baby unit Set screen off timer
Press and hold TALK and speak to your parent unit.
1. Press
Your voice is transmitted to the baby unit.
unit is idle.
2. Press
the submenu.
3. Press
automatically turn off screen
( /
Press and hold
press
NOTE
• Press any keys on the parent unit to turn on the screen
again.
Sound activation
When the baby unit detects no sound, the parent unit screen
stays off to save power. Once a sound is detected, the parent
unit screen turns on automatically.
It will then turn off again after 50 seconds of no sound detection.
appears
Insert the screws into the holes and
Drill two holes in the wall.
tighten the screws until only 1/4 inch of the
If you drill the holes into a stud, go to step 3.
-OR- screws are exposed.
If you drill the holes into an object other
than a stud, insert the wall anchors into
the holes. Tap gently on the ends with a
hammer until the wall anchors are flush with
the wall.
Use the menu
to enter the main menu when the parent Press to enter the menu, choose a menu item, or o enter the menu, choose a menu item, or
save a setting. You can use the parent unit for advanced
settings or operations, such as to adjust the baby unit
or to choose , then press to open
sound sensitivity or the temperature range for alerts.
While in the menu:
or to choose the desired time period to
• Press or to scroll among the menu options.
- 5 min./ - 30 min. / - 60min.), then
• Press to enter the desired sub-menu.
to confirm your selection.
• Press or to select an an item.
• Press to confirm your selection.
Submenu
Main menu
Align the wall mount holes on the baby
unit with the screws on the wall. Slide the
baby unit down until it locks into place.
Basic operation - Baby unit
Turn off the parent unit Turn off the baby unit
Slide ON/OFF switch to power off your parent Slide the ON/OFF switch to OFF to power off your baby unit.
unit.
Adjust the camera angle.
Specifications are subject to change without notice.
© 2017 VTech Communications, Inc. All rights reserved.
12/17. VM320_QSG_V1.
Document order number: 96-012036-010-100