Table of Contents
Advertisement
Problem
Water flows on the ground. The melting water outlet does not
The temperature in the ap-
pliance is too low/high.
If your appliance is still not working properly af-
ter making the above checks, contact the After
Sales Centre. You can find the list at the end of
this manual.
Replacing the control unit
The appliance is equipped with a longlife LED
interior light.
Technical data
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
10
Possible cause
flow in the evaporative tray above
the compressor.
The temperature regulator is not set
correctly.
Height
Width
Depth
Attach the melting water outlet to the
evaporative tray.
Set a higher/lower temperature.
Only service is allowed to replace the control
unit. Contact your Service Center.
Closing the door
1. Clean the door gaskets.
2. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
1850 mm
595 mm
658 mm
18 h
230-240 V
50 Hz
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
Solution
www.zanussi.com
Advertisement
Table of Contents
