Security Codes; Trouble Conditions; Volume - ADT Safewatch Quick Connect Plus Quick Manual

Security Codes

You can program up to 6 additional user codes.
To add a user, enter the [Master code] + [CODE] + [new user number] + [new user code].

To erase a user, enter the [Master code] + [CODE] + [user number] and wait approximately three

seconds for the keypad to beep and verify.
Some user numbers have already been programmed:
Pre-programmed User
Installer
Master
Babysitter
Duress
For a complete list of User Code Attributes, please see the

Trouble Conditions

When a trouble condition is detected, the word 'FAULT' will be displayed on the panel.
The existing Trouble Condition keyword will appear on the display.

To silence the Trouble Condition beeps, enter your [security code] + [OFF].

For a list of possible Trouble Conditions, please see the

Volume

System announcements and status beep volume can be adjusted.
To adjust the volume level, press [FUNCTION] + [VOLUME] + [3]/[6].

[3] increases the volume by one level and [6] decreases the volume by one level.

Function
All functions
All functions
Only arm the system.
Secretly notifies the
monitoring center of duress.
Safewatch Quick Connect Plus system manual.
Safewatch Quick Connect Plus system manual.
User Number
[1]
[2]
[7]
[8]