Programming The Remote To Operate Your Tv; Testing The Remote; Entering Codes - RCA RC5920P User Manual

Programming the Remote to Operate Your TV

The remote can be programmed to control most brands of remote controllable TVs. The remote is already
programmed to control most RCA, Proscan, and GE TVs.

Testing the remote

To determine whether the remote needs to be programmed, turn the TV ON, point the remote at the TV, and
press the TV button. Then press ON•OFF or CH+ (channel up) or CH- (channel down) to see if the TV
responds to the remote commands. If not, the remote needs to be programmed.

Entering Codes

To control a TV that is not from RCA, Proscan or GE, you'll need to enter the specific codes for the brand of
TV you have.
1. Turn on the TV to be programmed.
2. Look up the brand and code number(s) for the TV on the code list that's on the next page.
3. Point the DVD Player's remote at the TV.
4. Press and hold the TV button on the remote.
5. Enter the code from the code list that's on the next page.
6. Release the TV button, and then press ON•OFF to see if the TV responds to the command. If it doesn't,
try pressing the TV button and then ON•OFF again.
7. If you get no response, repeat these steps using the next code listed for your brand, until the TV responds
to the remote commands.
Note: This remote may not be compatible with all brands and models of televisions.
Important!
You must continue pressing the TV button while you enter the code.
For example, let's say you have a Zenith TV. To program the remote to operate the TV you would:
Press and hold the TV button while you enter the first code listed for Zenith in the TV Codes column.
Release the TV button. Press ON•OFF to see if the TV responds. If it doesn't, follow the same steps, but enter
the second code instead of the first.
Chapter 1
Connections & Setup
25