Advertisement
EVERY YEAR CARRY OUT THE FOLLOWING INSPECTION PROCEDURE
ALL INSPECTIONS SHOULD BE CARRIED OUT WITH THE RIDE ISOLATED FROM THE
ELECTRICAL SUPPLY.
MECHANICAL EXAMINATION
Mechanical examination should only be carried out by a competent person. (In the UK registered through
BACTA under the Amusement Device Inspection Procedure Scheme)
1.
Remove inspection covers and casings to allow a thorough examination of all moving parts and any
part of the machine which could conceivably be regarded as vital to the safe operation of the machine.
(Wherever fibreglass casings are removed work-wear gloves should be worn to protect skin from
internal fibreglass edges).
2.
Check all nuts/bolts and grub screws are tight and fitted with shake proof or spring washers.
3.
Check all bearings are in good condition and adequately lubricated.
4.
Check the ride's structure for any sign of damage or corrosion. Pay particular attention to welded joints.
5.
Check the condition of the 'V' belt and ensure that the belt is correctly tensioned.
6.
Check the lubrication level in the gearbox. Check gearbox seals for any sign of leakage.
7.
Check the gearbox for excessive backlash in the gear drive.
8.
Check for signs of wear in the gearbox crank assembly.
9.
Check the feet of the ride for signs of wear or damage.
10.
Remove any build-up of rubbish from the ride which may present a fire risk.
ELECTRICAL EXAMINATION
Electrical examination should only be carried out by a suitably qualified electrician who is competent in the
testing of portable appliances.
1.
Check the mains input lead for signs of damage and that correct polarity has been observed.
2.
Check all electrical connections for tightness and integrity. Check for any signs of damp, corrosion or
over-heating.
3.
Ensure all metal parts of the machine such as the base, stem or metal parts attached thereto which could
come into contact with or have connection to components which are supplied by mains voltage, are
securely earthed. All earth connections should be checked to ensure they are secure and free from dirt
or corrosion.
4.
Check the condition of all internal wiring. Ensure correct polarity has been observed.
5.
Check the rating of all lamps and fuses to ensure the correct type and rating are installed.
6.
Check the mains cable is secured to the ride using a cable restraint that is of the correct type.
7.
A portable appliance test should be carried out to determine earth continuity and insulation protection.
Instruments used to determine the test result should be capable of providing a reading that will
determine if the earth protection of the ride is deteriorating.
8.
Rides should be fitted with an RCB type trip.
Chuck 'E' Cheese Black & White Photo Ride Page 8
Advertisement
