Advertisement
HOW TO ADJUST THE STANDARD OPERATION OF THE RIDE
Volume Control (All Models)
The volume control knob is fitted to the timer which is situated behind the locked black door at the
side of the ride (beneath the printer). Opening this door gives access to live parts. Remove power
supply, open door, adjust volume, close door and check that volume is acceptable
Ride Time (Integrated Technology Timer)
The ride comes set to a standard ride time of 67 seconds. This can be adjusted to a maximum of + or -
30 seconds by either:-
1.
replacing the 8 pin IC4 chip with a new one programmed to the desired time
2.
by using a D plug programmer to re-programme the chip IC4 on site in + or - 15 seconds
intervals
3.
by using a micromate programmer to re-programme the chip IC4
The D plug and micromate programmer are options available at extra cost
Ride Time (Stamar System 2000 Timer)
The ride comes set to a standard ride time of 60 seconds. The ride time can be set to 45, 60, 75, 90 or
105 seconds.
Coins per Ride (Integrated Technology)
The cost per ride is set at manufacture. The cost per ride can be adjusted by:-
1.
replacing the 8 pin IC4 chip with a new one programmed to the desired credit setting
2.
using the micromate programmer to re-programme the chip IC4 to the desired credit setting
The Micromate programmer is an option available at extra cost
Coins per Ride (Stamar)
The price per ride can be adjusted by 3 DIL switches situated on the timer board. DIL switch settings
are indicated on the timer lid
WARNING
The Micromate programmer gives access to vital information on the timer's memory. This
programmer should only be used by competent persons after consultation with the manufacturers
Amutec's kiddie ride toys (not the characters) are manufactured in self coloured GRP. This material
can be maintained to a high standard using the following simple instructions
1.
Day to day cleaning
Wipe down with hot soapy water and polish with a silicone based polish. Ensure the power supply is
disconnected during this process and that water does not come into contact with any electrical items
CARE OF FIBREGLASS
Chuck 'E' Cheese Black & White Photo Ride Page 10
Advertisement
