Installation Of Decorative Panel - Lennox LT-B3021HW Installation Operating & Maintenance Manual

7. Installation of Decorative Panel

The decorative panel has its installation
direction.
1. Temporarily fix two decorative panel fixing screws (hexagon M5 screw) on the unit body. (Tighten by amount
10mm in length.)
The fixing screws (hexagon M5 screw) are included the decorative panel box.
2. Remove the air inlet grille from the decorative panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decorative panel key hole (
screws reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector.
6. After tightening these screws, install the air inlet grille (including the air filter).
Air conditioner unit
Louver motor connector
(In the control box)
Decorative panel fixing screws
(hexagon M5 screws)
Temporally fitting at 2 places
(Tightening about 10mm)
Decorative panel
Louver motor
connector
) on the screws fixed in step above, and slide the panel so that the
Piping side
Decorative panel fixing screws
(Hexagon M5 screw)
Inlet Grille
Before installing the decorative panel,
always remove the paper template.
Control box
cover
Key holes
–31–
Install the panel after
making sure that the
piping side of the unit body
matches the piping
indication of the decorative
panel
The arrow ( ) should point
to the side where the pipes are.