Fujitsu ASU18RLF Design & Technical Manual page 32

¢ Custom code setting for wireless remote controller
To interconnect the air conditioner and the wireless remote controller, assignment of the custom
code for the wireless remote controller is required.
NOTE: Air conditioner cannot receive a custom code if the air conditioner has not been set for
the custom code.
1. Press the START/STOP button until only the clock is displayed on the remote controller dis-
play.
2. Press the MODE button for at least 5 seconds to display the current custom code. (Initially
set to .)
3. Press the SET TEMP. (
Match the code on the display to the air conditioner custom code.
4. Press the MODE button again to return to the clock indicator. The custom code will be
changed.
NOTES:
• If no button is pressed within 30 seconds after the custom code is displayed, the system re-
turns to the original clock indicator. In this case, start again from step 1.
• The air conditioner custom code is set to
contact your retailer.
• The remote controller resets to custom code
replaced. If you use a custom code other than code , reset the appropriate custom code af-
ter replacing the batteries. If you do not know the assigned code for the air conditioner, try
each of the custom code ( → → → ) until you find the code which operates the air condi-
tioner.
or ) button to change the custom code between
prior to shipment. To change the custom code,
when the batteries in the remote controller are
- 28 -
→ → → .