Table of Contents
Advertisement
•
e is the HSC node number of the node being accessed. The /NODE
qualifier is not necessary if you are booting from a local disk. The
HSC node number is in hexadecimal. You can deposit a maximum
of two HSC node numbers (if two HSCs are available).
•
u is the unit number of the drive holding the system disk.
Example:
The following command specifies to boot from [SYSC] of an HSC disk with
a unit number of 1. The disk is connected to VAXBI node 2 of XMI node 3
and is available to two HSCs, node numbers 0E and 02.
>>> BOOT/R5:C0000000/XMI:3/BI:2/NODE:0E02 DU1
System Boot Procedures 4–9
Advertisement
Table of Contents
