Daikin FTXD60JV1B User Manual page 33

SiBE04-101.book Page 25 Monday, October 15, 2001 3:08 PM
SiBE04-101
Details of the
It can be commanded for J type by means of a user setting to select either any one desired position among
Action the five-step directions of air flow adjusted on a remote controller, or Auto-swing.
Although the liquid crystal display of the five-step directions of the air flow is common for the modes of
Cooling·Dry/Heating as illustrated above, in fact the range of the swing angle is slightly different in every
operation mode.
The position a user set will be selected among the five positions calculated through the preliminary and
evenly divided into four partitions which were taken from the upper and lower flap angle's range limits of
each mode.
When Auto-swing is chosen, the flap swings in the swing range which meets the operation mode selected.
Heating mode
0 degree based on
the horizontal line.
30˚
60˚
Outline of 3-D
Airflow
Details of the When the horizontal swing and vertical swing are both set to auto mode in J type, the airflow become 3-D
Action airflow and the horizontal swing and vertical swing motions are alternated. The order of swing motion is
such that it turns counterclockwise, starting from the right upper point as viewed to the front side of the
indoor unit.
Main Function
5
4
3
2
1
Initial
Cooling / Dry / Fan mode
0 degree based on
the horizontal line.
15˚
25˚
(R1021)
Alternative repetition of vertical and horizontal swing motions enables uniform air-conditioning of the
entire room. This function is effective for starting the air conditioner.
General Functions
5
1
4 2
3
Initial
(R1020)
Heating / Cooling / Dry / Fan mode
60˚
(R1022)
∗ Fan mode is available for the models of cooling-only.
(R1024)
60˚
(R1023)
25