Advertisement
EN 4
2.
SACD 900
Video Plus
"Video Plus+" and "PlusCode" are registered trademarks of the
Gemstar Development Corporation. The "Video Plus+" system
is manufactored under licence from the Gemstar Development
Corporation.
Figure 2-5
Macrovision
This product incorporates copyright protection technology that
is protected by method claims of certain U.S. patents and other
intellectual property rights owned by Macrovision Corporation
and other rights owners.
Use of this copyright protection technology must be autorized
by Macrovision Corporation, and is intended for home and
other limited viewing uses only unless otherwise authorized by
Macrovision Corporation. Reverse engineering or disassembly
is prohibited.
2.3
Service Hints
2.3.1
Switched Mode Power Supply 1005
This power supply unit has to be repaired down to component
level in case of failure.
2.3.2
SACD Module
This module can be repaired as follows:
1. The loader and DVD-Mechanism (VAL6011) is one
assembly. This assembly is a not repairable unit and must
be exchanged completely in case of failure. A new unit can
be ordered with codenumber 9305 023 61104.
2. The mono board has to be repaired down to component
level. Repair handling of the monoboard requires a
workshop with sophisticated desoldering tools.
2.3.3
ComPair
For assistance with the repair process of the monoboard an
electronic fault finding guidance has been developed, this
program is called ComPair.
This ComPair program is available on CDROM.
The version of the CDROM for repair of the monoboard is V1.3
or higher and can be ordered with codenumber: 4822 727
21637. This is an update CDROM, so when the ComPair
CDROM is used for the first time, one has to install the ComPair
Engine CDROM V1.2 first.
The V1.2 CDROM can be ordered with code number 4822 727
21634 and has to registered after instalation. The procedure for
registration is explained in the help file of the program and in
the CDROM booklet.
The cable to connect the monoboard with a PC can be ordered
with codenumber: 3122 785 90017.
All the hardware and software requirements of the systems
necessary for working with ComPair is described on the
CDROM.
2.3.4
Service Positions
SACD Module
Refer to dismantling instructions for dismounting of the board.
Figures 2-1 to 2-3 shows the service position that are
recommended during repairing of the boards.
Safety Instructions, Warnings, Notes, and Service Hints
Mono Board
Figure 2-6
AV Board
Figure 2-7
P-Scan Board
Figure 2-8
Advertisement
