Lamp And Its Replacement; Error Codes & Auto Test - Hotpoint SXBD922FWDUK Manual

Indesit Company

Lamp and its Replacement

The parameters of the lamps of the refrigerator, freezer and
distributor and the replacement lamps are direct current
(DC) 12V, LED.
When lamps are replaced:
• Unplug the plug to cut off the power.
• Push and remove the lampshade according to the
direction in the attached drawing. Remove the screws
and the LED lamp.
• Reassemble them in the opposite process.
• Replacement should be done by a professional.
ERROR CODES & AUTO-TEST
Error Code and Input Circuit
Error Code Relative Circuit
E1 Temp Test Circuit for Refrigerator Compartment
E2 Temp Test Circuit for Freezer Compartment
E3 Freezer Defrosting Temp Test Circuit
E8 Ambient Temp Sensor Fault
E0 Ice maker Fault
EE Ice maker Temp Test Circuit
Technical Specs and Functioning of Ice Maker
It is controlled by the Ice maker switch on the control display panel to start or stop ice making.
The procedure for ice-making is as below:
For the first time, turn on the water valve to let water in (time set 5 seconds). Start ice building.
70 minutes later, after measuring that the temp of ice is less than -15°C, keep 5 minutes. When the
ambient temp is less than 8°C, keep 20 minutes for -10°C. Revolve ice making motor to push ice into
ice storage box. If the box is not full filled, repeat the cycle again. If the box is full, exit from ice making
procedure.
15 of 17