Function Introduction - Hotpoint SXBD922FWDUK Manual

A+frost free side by side fridge freezers
Table of Contents

Advertisement

Indesit
Company

FUNCTION INTRODUCTION

A. Operation of Automatic Ice Maker
1.
Automatic ice maker operates when the freezer reaches the needed temperature below 0? after
a period prescriptive time when the refrigeratory is energized. Under normal temperature, the
time between the refrigeratory's first energizing and first making of ice is about 6 hours.
2.
The ice firstly made after the installation of the refrigeratory shall be thrown away because of
plastic smell and impurities.
3.
The time interval of ice making is about 2 hours, and the amount of the ice is different according
to different service conditions.
4.
When the ice storage is full, the ice maker will stop automatically, and when the ice storage is
empty, the ice maker will make ice again automatically.
5.
The noises for de-icing, motor operation, dropping of ice into the ice storage, and operation of
water supply valve may not happen periodically. They are not errors.
6.
Please use the button on/off on the distributor to turn off the ice-making function when it is not
required. The ice maker is sold under ON state. If unnecessary, please turn off this function
timely after installation of the refrigeratory. When the ice-making function is turned on without
connection of waterways, there are operational noises of water supply valve.
7.
When ice piece is smaller than usual in a certain period of time, please verify the replacement
frequency of the filter. When the filter reaches its operation time, the water supply pressure is
lower and the made ice piece is smaller.
8.
When cleaning the ice storage box, turn off the ice-making function on the distributor before
detaching the ice storage box.
9.
Do not whirl the Auger during reinstallation of the removed ice storage box. After being whirled,
the Auger cannot be assembled and installed normally. It may be damaged when taking out the
ice. Whirl the Auger left and right after it has been whirled to ensure normal installation.
B. Supply of Ice
1.
Choose the ice/ water button on the display board, select entire
or crushed ice pieces and make sure the relevant indicator
turns on.
2.
Use the container to push and hold the switch plate to get ice.
3.
According to the water supply condition, some mixed small ice
pieces may come out when getting the entire ice pieces.
4.
When crushed ice pieces are required, please press the
container most close to the ice discharging orifice to prevent the
crushed ice from dropping out.
5.
When getting ice, the noises of motor, crushing ice and so on
are normal.
6.
To protect the motor, the refrigeratory will stop when the switch
plate is pushed for 1 minute or more. Then, releasing the switch
plate and waiting a moment, you can get ice normally again.
When large amount of entire ice pieces are required, please
open the door of freezer, take the ice storage box out and use the ice in it.
9 of 17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sxbd925fwduk8416684163

Table of Contents