Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kärcher HDS 796 CW
Summary of Contents for Kärcher HDS 796 CW
- Page 1 HDS 796 CW www.karcher.com 5.959 - 421 (09/99) 1.173...
- Page 2 HDS 796 CW...
- Page 3 HDS 796 CW Operating Instructions Spare Parts List Prior to initial startup, operating manual and safety instructions no. 5.951-949 must be consulted...
-
Page 4: Table Of Contents
English HDS 796 CW Maintenance CONTENTS Maintenance intervals Important Safety Instructions Maintenance work Clean strainer in water Environmental protection connection Clean strainer in low water Overview protection Commissioning Clean filter at cleaning-agent Checking oil level suction hose Filling with fuel... -
Page 5: Important Safety Instructions
English HDS 796 CW * DO NOT USE GASOLINE, Only Identical Replacement IMPORTANT SAFETY CRANCASE DRAININGS, OR OIL Parts.“ INSTRUCTIONS Prior to initial startup, operating CONTAINING GASOLINE OR * WARNING Risk of injection or manual and safety instructions SOLVENTS. injury-Do Not Direct Discharge * WARNING: RISK OF INJECTION Stream At Persons. -
Page 6: Overview
English HDS 796 CW OVERVIEW COMMISSIONING Filling with fuel Mounting handgun Fig. 1 – Connect spray lance to handgun 1 Swivel caster with parking brake – Insert high-pressure nozzle in – Unit, piping, high-pressure hose – Never operate unit with fuel tank... -
Page 7: Drawing In Water From Tank
English HDS 796 CW Drawing in water from tank Mains connection OPERATION Setting cleaning temperature The following conversion work is Refer to technical data and rating Set selector switch (1) to desired necessary if water is to be drawn in plate for connected loads. -
Page 8: Intended Use
English HDS 796 CW – Engage spray lance in cover Intended use Cleaning Operation with hot water holder – Roll up high-pressure hose and Cleaning of: Machines, vehicles, * Set pressure/temperature and * Danger of scalding cable and place in compartment... -
Page 9: Frost Protection
English HDS 796 CW FROST PROTECTION MAINTENANCE Maintenance intervals The unit has a frost protection Once a week Caution: feature, which avoids freezing of the – Clean strainer in water connection The unit may not be separated from * Disconnect unit from mains before watersystem down to -30 °C. -
Page 10: Clean Strainer In Low Water Protection
English HDS 796 CW Clean strainer in low water Clean filter at cleaning-agent Change oil protection suction hose KÄRCHER tip – Provide a collecting container for * Cut open RM 110 bottle and use – Pull out cleaning-agent suction approx. 1 litres of oil... -
Page 11: Faults
English HDS 796 CW If fault cannot be rectified, have FAULTS unit checked by After-Sales Service. Cause Remedy Fault – Fuel tank empty Fill up FUEL indicator lamp on READY FOR OPERATION – Motor overloaded/overheated Set selector switch to "0" and allow... - Page 12 English HDS 796 CW Fault Cause Remedy If fault cannot be rectified, have unit checked by After-Sales Unit leaking, water dripping out at – Pump leaking 3 droplets/min are permitted. Service. bottom In the event of a major leak, have unit checked by After-Sales Service.
-
Page 13: Warranty
English HDS 796 CW * Low water protection WARRANTY GENERAL NOTES The low water protection stops the burner being switched on in the The warranty terms and conditions event of a lack of water. A strainer issued by our responsible sales... -
Page 14: Technical Data
English HDS 796 CW TECHNICAL DATA HDS 796 CW-50 (1.173-114) HDS 796 CW-60 (1.173-115) Type Mains connection 200 V 120 V 3~ 50 Hz 1~ 60Hz Connected load 3.0 kW 3.1 HP Engine output 2.2 kW Fuse (slow blow) 13 A... - Page 15 HDS 796 CW...
Need help?
Do you have a question about the HDS 796 CW and is the answer not in the manual?
Questions and answers