Page 2
If operating a power tool in damp location is unavoidable, use a residential current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock.
ELECTRONICS The built-in electronic will keep a constant speed even under increased load. In case of overload, the rotational speed is being reduced until machine stops. The machine has an overload and anti-kickback safety function and stops if it is overloaded.Please note that the machine will automatically accelerate back to its original operating speed if the load is removed from it.After it has reached its operating...
Page 5
SYMBOLOGY CAUTION! WARNING! DANGER! Please read the instructions carefully before starting the machine. Always wear goggles when using the machine. Wear gloves! Always disconnect the plug from the socket before carrying out any work on the machine. Do not use force. Only for cutting work.
Page 6
Grinding Wheel Selection Use grinding wheels, and accessories that are: Care of Grinding & Cut-Off Wheels 1/8” Flange nut position for 3.2 mm (1/8") thick or less wheels 1/4” Flange nut position for 6.4 mm (1/4") thick or more wheels...
Page 7
To start the tool, grasp the handle and side handle firmly. Disengage the lock out lever by pushing forward and then squeeze in the paddle switch towards the body of the tool. To stop the tool, release the paddle switch. Make sure the tool comes to a complete stop before laying the tool down.
Page 9
Please state the Article No. as well as the machine type printed on the label and order the drawing at your local service agents or ® directly from MILWAUKEE Australia (Toll Free Telephone Number: 1300 361 505 / E-mail: milwaukee@ttibrands.com.au)
SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE ® prides itself in producing a premium quality product that is Nothing But Heavy Duty ® . Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE ®...