General Operational Precautions; Specifications - Hitachi C 15FB Handling Instructions Manual

English

GENERAL OPERATIONAL PRECAUTIONS

1. Keep work area clean. Cluttered areas and benches
invite accidents.
2. Avoid dangerous environment. Don't expose power
tools to rain. Don't use power tools in damp or wet
locations. And keep work area well it.
3. Keep children away. All visitors should be kept at
safe distance from work area.
4. Store idle tools. When not in use, tools should be
stored in dry, high or locked-up place—out of reach
of children.
5. Don't force tool. It will do the job better and safer
at the rate for which it was designed.
6. Use right tool. Don't force small tool or attachment
to do the job of a heavy duty tool.
7. Wear proper apparel. No loose clothing or jewelry
to get caught in moving parts. Rubber gloves and
footwear are recommended when working outdoors.
8. Use safety glasses with most tools. Also face or dust
mask if cutting operation is dusty.
9. Don't abuse cord. Never carry tool by cord or yank
it to disconnect from receptacle. Keep cord from
heat, oil and sharp edges.
10. Secure work. Use clamps or a vise to hold work.
It's safer than using your hand and it frees both
hands to operate tool.
11. Don't overreach. Keep proper footing and balance
at all times.
12. Maintain tools with care. Keep tools sharp at all
times, and clean for best and safest performance.
Follow instructions for lubricating and changing
accessories.
13. Disconnect tools. When not in use, before servicing;
when changing accessories such as blades, bits,
cutters, etc.

SPECIFICATIONS

Max. sawing dimension
Height × Width
Angular sawing range
Input:
No-Load Speed:
Weight:
* For how to cut materials marked "*", refer to page 6: "How to cut wide materials".
** Be sure to check the nameplate on product as it is subject to change by areas.
3
14. Remove adjusting keys and wrenches. Form habit
15. Avoid accidental starting. Don't carry plugged-in
16. Outdoor use extension cords. When tool is used
17. Do not use power tools for applications other than
18. Never use power tools near inflammable or explosive
19. To ensure the designed operational integrity of power
20. Do not touch movable parts or accessories unless
21. Use your tool at lower input than specified on the
22. Never use the miter saw with its safety cover fixed
23. Ensure that the safety cover moves smoothly and
24. Always keep the saw blade sharp.
25. Never operate the miter saw with the saw blade
26. Ensure that the workpiece is free of foreign matter
27. Consult an authorized Service Agent in the event
28. Use only original HITACHI replacement parts.
29. This tool should only be disassembled for
122 mm (4-3/4") × 185 mm (7-1/4")
90°
[45 mm (1-3/4") × 240 mm (9-7/16")]*
122 mm (4-3/4") × 139 mm (5-7/16")
45°
[150 mm (5-7/8") × 45 mm (1-3/4")]*
of checking to see that keys and adjusting wrenches
are removed from tool before turning it on.
tool with finger on switch. Be sure switch is off
when plugging in.
outdoors, use only extension cords suitable for use
outdoors and so marked.
those specified in the Handling Instructions.
materials.
tools, do not remove installed covers or screws.
the power source has been disconnected.
nameplate: otherwise, the finish may be spoiled and
working efficiency reduced due to motor overload.
in the open position.
freely.
turned upward or to the side.
such as nails.
of power tool failure.
replacement of carbon brushes.
Right and left 0°
1640 W**
3400/min
25 kg
57°