Film Protection - Blackmagicdesign Cintel Installation And Operation Manual

Adjusting the horizontal position of the
stabilization overlay. In this screenshot,
the overlay is not aligned with the edge
of the perf.
TIP To closely check the results of your stabilization settings before capturing, set the
viewer to full resolution. Simply click on the options settings at the top right corner of
the viewer and select 'Full Resolution Preview' from the drop down menu. This setting
does not affect the stabilization feature, but enables the best possible preview so you
can monitor how well it is performing.
It's worth mentioning that this setting will remain set until you change it back to your
previous setting. Full resolution is very GPU intensive and may result in some frame lag.
For best performance, turn full resolution off after checking stabilization.

Film Protection

These controls are intended to allow delicate film to be handled gently by the Cintel Scanner.
Fast acceleration and shuttle speeds can be hard on archival footage, so it's recommended to
lower both of these sliders from their defaults whenever you're scanning older film.
The 'Acceleration' and 'Shuttle Speed' sliders should be
lowered when scanning older, delicate archival film
Max Acceleration:
second per second.
Changes the scanning speed to operate between 5–30 frames per
Hardware stabilization control correctly
positioned over a perforation in the viewer.
The transparent stripe in the stabilization
overlay touches the edge of the perforation.
Capturing from Cintel using DaVinci Resolve 23