Hitachi RP 35YB Handling Instructions Manual page 38

English
tank at least once a day and keep the appliance,
the filter, etc. clean. Otherwise suction power fall,
motor failure, bad smell or rusting may be caused.
Do not hold the clamps when you dump dusts in
the tank. Otherwise the clamps may be damaged.
NOTE
Do not tilt the tank with accessories (Pipe, Master
nozzle, etc.) inserted in the base or in the tank.
Otherwise any part may be damaged.
In the case of RP35YB
WARNING
If the appliance is pushed on its side while the tank
contains liquid, the liquid will get inside the motor
or switch region, causing an electric shock or motor
failure.
(1) Remove the clamps (2 pieces) and raise the handle
of the head. (Fig. 11)
(2) Lightly striking the inner side of the filter several
times, remove dusts attached to the filter.
(3) Tilt the tank and dump dusts. (Fig. 12)
(4) Attach the filter, the filter cage, the head, and the
clamp in the initial positions.
In the case of RP35YE
CAUTION
Put the vacuum switch in "OFF" and push the filter
cleaning switch to remove dusts from the filter.
Then, after waiting about 1 minute, dump dusts of
the tank.
(1) Detach the clamps (2 pieces) and raise the handle
of the head. (Fig. 11)
(2) Dump dusts in the tank. (Fig. 13)
(3) Attach the head and the clamps in the original
positions.
9. Transportation and storage
(1) How to use the handle
When carrying or moving the appliance, hold the
handle of the head part as shown in the Fig. 14.
When you do not use the handle, put it in the head
part.
(2) Fixation and release of the caster
By lowering the lever of the caster with the brake,
the rotation of the wheel is fixed. When releasing
the fixed wheel, raise the lever. (Fig. 15) When
moving with the appliance on a vehicle, fix the
caster to retain the appliance. However, when you
move the appliance, check that the caster is released,
or the caster will be damaged.
(3) When the appliance is stored
When you want to interrupt cleaning for a moment,
you can hook the pipe holder of the pipe. The
appliance can be then stored. The cord can also
be bundled and hooked. (Fig. 16)
10. Suction shutoff device
In the case of RP35YE
WARNING
Avoid sucking in foaming liquids such as detergent
or foam. Before the suction shutoff device operates,
foam may spurt from the air outlet.
If you continue to use the appliance as it is, it will
lead to electric shock or failure.
This appliance is equipped with a suction shutoff
device to prevent water from entering the motor
when it sucks in more than a specific quantity of
water.
37
When the suction shutoff device operates, the motor
stops automatically and suction stops.
When the suction shutoff device operates to stop
the motor, turn off the switch promptly, disconnect
the plug from the power receptacle and throw away
the water in the tank.
11. How to attach the paper filter (Optional)
WARNING
Be sure to turn off the appliance and remove the
plug from the electric outlet.
When using a paper filter, use it in combination
with the standard cloth filter. [In the case of RP35YE,
use in combination with the standard dust filter.]
If the paper filter gets torn, dust may get inside the
motor, causing abnormal noise or fire due to
overheating.
CAUTION
When using a paper filter, avoid sucking in liquids
such as water or wet dust, as this may lead to
tearing of the filter.
[RP35YE]
(1) Open the paper filter vertically so that the suction
hole in the paper filter is over the top of the tank.
(Fig. 17)
(2) Before attaching the filter to the appliance, bend
the two folds in the cardboard approx. 90° in the
direction of the arrow. (Fig. 18)
(3) Match the suction hole in the paper filter with the
suction opening of the appliance. Insert the filter in
the direction of the arrow as shown in the illustration,
so that the cardboard of the paper filter goes past
the stopper on the suction opening. (Fig. 19)
[RP35YB]
(1) Open the paper filter horizontally so that the suction
hole in the paper filter is over the top of the tank.
(Fig. 17)
(2) Before attaching the filter to the appliance, bend
the two folds in the cardboard approx. 90° in the
direction of the arrow. (Fig. 18)
(3) Match the suction hole in the paper filter with the
suction opening of the appliance. Insert the filter in
the direction of the arrow as shown in the illustration,
so that the cardboard of the paper filter goes past
the stopper on the suction opening. (Fig. 20)
FLOAT MECHANISM
In the case of RP35YB
This appliance is equipped with a float mechanism
to prevent water from entering in the motor when
it sucks in more than a specific quantity of water.
When the float operates not to suck in water, turn
off the switch promptly and throw away water in
the tank.
WARNING
With the float working, do not continue operation.
Otherwise the temperature of the motor may rise
abnormally causing troubles such as deformation
of parts or motor burnout.
Avoid sucking in foaming liquid such as detergent
or foams. Before the float works, foams may spurt
from the air outlet. If you continue to use the appliance
as it is, it will lead to electric shock or failure.