Cisco ASA Series Getting Started page 18

ASA 5506-X, 5508-X, and 5516-X Default Configuration
Procedure
Step 1 For failover, power off the standby unit.
To prevent the standby unit from becoming active, you must power it off. If you leave it on, when you erase
the active unit configuration, then the standby unit becomes active. When the former active unit reloads and
reconnects over the failover link, the old configuration will sync from the new active unit, wiping out the
deployment configuration you wanted.
Step 2 Restore the deployment configuration after you reload. For failover, enter this command on the active unit:
write erase
Note
Step 3 Reload the ASAv and load the deployment configuration:
reload
Step 4 For failover, power on the standby unit.
After the active unit reloads, power on the standby unit. The deployment configuration will sync to the standby
unit.
ASA 5506-X, 5508-X, and 5516-X Default Configuration
The default factory configuration for the ASA 5506-X series, 5508-X, and 5516-X configures the following:
• inside --> outside traffic flow—GigabitEthernet 1/1 (outside), GigabitEthernet 1/2 (inside)
• outside IP address from DHCP, inside IP address—192.168.1.1
• (ASA 5506W-X) wifi <--> inside, wifi --> outside traffic flow—GigabitEthernet 1/9 (wifi)
• (ASA 5506W-X) wifi IP address—192.168.10.1
• DHCP for clients on inside and wifi. The access point itself and all its clients use the ASA as the DHCP
• Management 1/1 interface is Up, but otherwise unconfigured. The ASA FirePOWER module can then
• ASDM access—inside and wifi hosts allowed.
• NAT—Interface PAT for all traffic from inside, wifi, and management to outside.
The configuration consists of the following commands:
interface Management1/1
management-only
no nameif
no security-level
no ip address
no shutdown
CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5
18
The ASAv boots the current running image, so you are not reverted to the original boot image. To
use the original boot image, see the boot image command.
Do not save the configuration.
server.
use this interface to access the ASA inside network and use the inside interface as the gateway to the
Internet.
Getting Started