Godox LED 36 Instruction Manual

LED Video Light
Instruction manual | 说明手册
Model: LED 36
Chinese English Bilingual | 中英文双语
Foreword:
Thank you for purchasing this Godox Product!
LED36 video light is excellent for macrophotography, product shooting, and
video recording, etc. This lightweight and portable light provides high
brightness and accurate color temperature. You can flexibly control the light
brightness by using the dimmer and by interlocking multiple lights.
Warning:
Always keep this product dry. Do not use in rain or in damp conditions.
Do not disassemble. Should repairs become necessary, this product must
be sent to an authorized maintenance center.
Keep out of reach of children.
As this product do not have waterproof function, please take measures of
waterproof in rainy or damp environment.
Do not use or store the product if the ambient temperature reads over 50°C.
Do not use the flash unit in the presence of flammable gases, chemicals and
other similar materials. In certain circumstance, these materials may be
sensitive to the strong light emitting from this flash unit and fire or
electromagnetic interference may result.
Observe precautions when handling batteries
● Do not put batteries into a fire or apply direct heat to them.
● Batteries are prone to leakage when fully discharged. To avoid
damage to the product, be sure to remove batteries when the
product is not used for a long time or when batteries run out of
charge.
● Should liquid from the batteries come into contact with skin or
clothing, rinse immediately with fresh water.
Parts:
01. 36 LED Beads 06. Locking Ring A
02. Power Switch 07. Locking Ring B
03. Brightness Controller 08. Camera Hotshoe Connection
04. Battery Compartment 09. 1/4" Bracket Mounting Hole
05. Light Hotshoe Connection
03
01
02
05
04
06
07
08
09
Installation and Operation
1.Installing the Video Light
Screw the Locking Ring A (06) and B (07) to the
highest point so that the light is fixed and insert the
Camera Hotshoe Connection horizontally into the
hotshoe of a camera or a camcorder.
Tighten the Locking Ring B (07).
Note: If your camcorder has no hotshoe connection, you are advised to purchase a
connecting bracket for camcorder. The video light has a 1/4" Bracket Mounting Hole as
your camcorder does. Therefore, you can easily connect both the light and the
camcorder to the bracket.
2.Using the Video Light
Open the Battery Install batteries (2*AA) Switch the power on,
Compartment (04). according to indications the video light giving
in the compartment and out light.
then close it.
Turn the Brightness Controller (03) to adjust the
brightness.
Turn the power off if it will not be used.
3.Interlocking Multiple Video Lights
Through the Light Hotshoe Connection
(05) and Camera Hotshoe Connection
(08), multiple video lights can be
interlocked together to strengthen the
lighting brightness and get a better
control of the lighting effects.
Technical Data:
Battery Two AA batteries
<1.3W
Power
Approx. 1.5 hours with alkaline batteries
Duration
5500~6500K
Color Temperature
>260Lux (0.5m)
Brightness
Stepless
Brightness Control
36
LED Beads Quantity
Operation Temperature -10~40℃
Dimension
70*89*38mm
Net weight
80g
* Product design and specifications are subject to change without notice.