Draper 88192 Instructions

550mm precision mitre saw

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THE

SAFE AND EFFECTIVE USE OF THIS PRODUCT.

INSTRUCTIONS

These instructions accompanying the product are the original instructions. This document is part of the product,

keep it for the life of the product passing it on to any subsequent holder of the product. Read all these

instructions before assembling, operating or maintaining this product.

This manual has been compiled by Draper Tools describing the purpose for which the product has been

designed, and contains all the necessary information to ensure its correct and safe use. By following all the

general safety instructions contained in this manual, it will ensure both product and operator safety, together

with longer life of the product itself.

AlI photographs and drawings in this manual are supplied by Draper Tools to help illustrate the operation of the

product.

Whilst every effort has been made to ensure the accuracy of information contained in this manual, the Draper

Tools policy of continuous improvement determines the right to make modifications without prior warning.

550mm

PRECISION

MITRE SAW

88192

Table of Contents

Need help?

Do you have a question about the 88192 and is the answer not in the manual?

Page 1 AlI photographs and drawings in this manual are supplied by Draper Tools to help illustrate the operation of the product.
Page 2 PARTS DRAWING AND COMPONENTS Saw and Guide Assembly Vice clamp assembly. Length stop assembly. Cut depth stop. Cut depth stop screws. Base. Base socket head screws. Pre-set angle arm. Pivot pin. Fence and Fence Stud Cursor screw. Assembly Cursor. Blade tensioning nut. Pivot screw.
Page 3 NOTES - 3 -...
Page 4 ©Published by Draper Tools Limited. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical photocopying, recording or otherwise without prior permission in writing from Draper Tools Ltd.