Replacing the power button
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
NOTE: Only steps 2 and 3 need to be performed if the power button does
not have the optional fingerprint reader.
1
Place the fingerprint-reader board into its slot on the palm-rest assembly.
2
Place the power button into its slot on the palm-rest assembly.
3
Pressing down on the power button, replace the two screws (M1.4x1.7) that
secure the power button to the palm-rest assembly.
4
Adhere the power button cable to the keyboard.
5
Replace the screw (M1.6x1.5) that secures the fingerprint-reader board to the
palm-rest assembly.
Post-requisites
1
Replace the
system
2
Replace the fans.
3
Replace the
heat
4
Replace the
solid-state
5
Replace the battery.
6
Replace the
base
56
computer. After working inside your computer, follow
After working inside your
board.
sink.
drive.
cover.
computer. For more safety best
www.dell.com/
Before