Table of Contents
Advertisement
Chapter 4: Additional Information
How to Find Your TV's Video Input Channel
You must tune your TV to the video input channel if you are using the IP video decoder's Audio/Video (A/
V) OUT jacks to connect to the TV's A/V input jacks. You must select the TV's video input channel before
you can see the decoder's menus or programming.
The video input channel for TVs varies by brand and model. Below are some steps to try to find your TV's
video input channel:
AUX
ON • OFF
TV
VIDEO
WEB
EMAIL
VOD
MUTE
HOME
CH +
CH -
GUIDE
MENU
KEYBD
TOOLS
INFO
OK
SELECT
BACK
EXIT•CLEAR
1
2
3
4
5
6
7
8
9
AUDIO•INPUT
ANTENNA
0
REV•REPLAY
PLAY
FWD•SKIP
RECORD
STOP
PAUSE
If you programmed your remote control to
operate your TV (instructions on page 14),
and you are using audio/video jacks, press
the AUDIO•INPUT button to find the Video
Input Channel.
26
Illustrations contained in this document are for representation only.
• If your TV brand is RCA, GE, or Proscan, press the TV
button on the decoder's remote control, then press the
AUDIO•INPUT button.
• If you have another brand of TV, see page 14 to see if the
decoder's remote can be programmed to control your TV.
If so, once completed, follow the step above.
If those options do not work, try the following ideas. You
might access the video input channel by:
TV button
• Pressing a button on the TV's remote control (see the
table below).
• Selecting a specific channel from the TV's on-screen menu
system (see the table below).
• Tuning directly to the video input channel by selecting a
specific channel number (see the table below)
• Going through all available channels by pressing the
channel up or down buttons on the TV or its remote
control.
Button/Switch
on the TV
VIDEO
SIGNAL
VID 1
AUDIO• INPUT
button
VID 2
S-VID
S-VIDEO
Video Input Channel Variations
Button on the
TV Remote
VID 1
LINE
VID
VIDEO
S-VID
INPUT
S-VIDEO
SOURCE
AUX
Channel
Number
00
90
91
92
93
VID 1
VID 2
Chapter 4
Advertisement
Table of Contents
