Table of Contents
Advertisement
Using the INPUT Button
Use the INPUT button to scroll through the available Video Input Channel sources for a TV or VCR and
regular broadcast signals. The Video Input Channels allow you to view images from a component
connected to the TV or VCR (such as a camcorder or DVD player).
1. Press the remote control's TV or AUX button (if programmed) to enter the corresponding mode. Make
sure the component is turned ON.
2. Press the remote control's INPUT button to tune to the Video Input Channel.
3. To tune back to the broadcast signal you were previously watching through the TV or VCR, press the
INPUT button again.
Volume Punchthrough
You may find this feature helpful if you've connected your components to an audio/video receiver (A/V
receiver) or amplifier, but you want to use the decoder's remote control to operate the volume.
Let's say you've connected your IP video decoder to your audio/video receiver. You've also programmed
your decoder remote control to operate your receiver. Since the decoder gets its volume through the
receiver, you would have to tell the remote you wanted to change the volume on the receiver each time
by pressing the AUX button first. With Volume Punchthrough, you can control the receiver's volume,
even when the remote is in decoder mode. Just use the volume buttons as normal, and you'll change the
receiver's volume automatically (or whatever volume component you used last).
IMPORTANT: You must first program the AUX button on the decoder's remote control to operate your audio
receiver or amplifier. Go to page 14 for instructions. If you can't program this remote to operate your audio
receiver, Volume Punchthrough won't work.
Chapter 2
Illustrations contained in this document are for representation only.
Chapter 2: Remote Control
13
Advertisement
Table of Contents
