Pride C1 Owner's Manual page 21

V. OPERATION
Follow these steps to operate the massage option (Fig. 5.2):
1. Press the MASSAGE button once to activate the massage function. This will automatically set the mas-
sage to the wave setting.
2. Press the MASSAGE button again to go to the next of three available massage settings: wave, steady, or
pulse. Each press of the button will take you to the next setting. Each setting is indicated by a colored LED.
3. Press and hold the MASSAGE button for approximately 2 seconds to shut off the massage function,
otherwise this function will shut off automatically after 20 minutes of continuous use.
Follow these steps to adjust the intensity of the massage function (Fig. 5.2):
1. Press the INTENSITY button once to set the massage option to low.
2. Press the INTENSITY button again to set the massage option to the next of three available settings: low,
medium, or high. Each press of the button will take you to the next setting. Each setting is indicated by a
colored LED.
NOTE: Pride recommends that the heat and massage units not be used for more than 20 minutes at
a time. However, you should consult your physician about how often you should use the heat and
massage options on your lift chair.
Dual Motor Hand Control Operation
Follow these steps to sit in your lift chair (Fig. 5.3):
1. Slide the inhibit switch to the right.
2. Engage and hold the up/down switch in the UP position
to raise your lift chair from the seated position to the
standing position.
3. Back into the lift chair and sit in the center of the seat,
using the armrests for support if needed.
4. Engage and hold the up/down switch in the DOWN posi-
tion to lower the lift chair to a comfortable seated position.
Follow these steps to recline your lift chair from the
seated position (Fig. 5.3):
1. Slide the inhibit switch to the left.
2. Engage and hold the up/down switch in the DOWN posi-
tion until comfortably reclined.
3. Engage and hold the up/down switch in the UP position
to return to an upright, seated position. Release the
switch when the lift chair reaches a comfortable seated
position.
Follow these steps to raise or lower the footrest while in the seated or reclined position (Fig. 5.3):
1. Slide the inhibit switch to the right.
2. Engage and hold the up/down switch in the DOWN position until the footrest reaches a comfortable
height.
3. Engage and hold the up/down switch in the UP position to lower the footrest.
Follow these steps to stand up from your lift chair from the seated position (Fig. 5.3):
1. Slide the inhibit switch to the right.
2. Engage and hold the up/down switch in the UP position to raise your lift chair.
3. Release the switch when the lift chair reaches a height where you can stand up comfortably.
Lift Chair Series
Figure 5.3 Dual Motor Hand Control
www.pridemobility.com
LIFT CHAIR SERIES
DOWN
POSITION
INHIBIT
SWITCH
UP
POSITION
21