This product has been tested and complies to IEC 60601-1-2. Properly dispose of all electronic components, including the external transformer, hand control, batteries, actuator motors and wiring. Contact your authorised Pride Dealer for more information. Lift Chair Series www.pridemobility.com...
Page 4
LIFT CHAIR SERIES LABEL INFORMATION Do not place objects under lift chair. Make sure area is clear of obstructions, including pets and small children during operation. Do not place objects under the footrest when lift chair is in fully reclined position.
LIFT CHAIR SERIES TABLE OF CONTENTS SAFETY GUIDELINES ..................2 LABEL INFORMATION ..................3 I. INTRODUCTION ....................6 SAFETY ..................................6 PURCHASER’S AGREEMENT.............................6 INFORMATION EXCHANGE............................6 II. GENERAL GUIDELINES ................... 7 MODIFICATIONS .................................7 WEIGHT LIMITATIONS ..............................7 PINCH/CRUSH HAZARDS ............................7 DEGREE OF PROTECTION/MODE OF OPERATION ....................7 STORAGE AND OPERATION TEMPERATURES .......................7 EMI/RFI ..................................8 SHIPPING AND DELIVERY ............................8...
MODIFICATIONS Pride has designed and engineered your lift chair to provide maximum comfort and utility. However, to pre- vent personal injury and/or damage to your lift chair, you should not modify, add, remove or disable any feature, part or function of your lift chair.
WARNING! Your lift chair itself can disturb the performance of other electrical devices located nearby, such as alarm systems. NOTE: If unintended motion occurs, discontinue use of the lift chair. Contact Pride to report the incident. SHIPPING AND DELIVERY Before using your lift chair, make sure your delivery is complete as some components may be packaged individually.
This section describes the features of your lift chair. Carefully review the function and location of each item described. POWER LEAD EXTERNAL TRANSFORMER LOW VOLTAGE CONNECTION CABLE SCISSOR MECHANISMS REMOVABLE (PINCH POINT) CHAISE PAD LIFT MECHANISM (PINCH POINT) LEG LEVELERS (FOUR TOTAL) Figure 3.1 Pride Lift Chair Main Components Lift Chair Series www.pridemobility.com...
Figure 3.3 Scissor Mechanism ELECTRICAL COMPONENTS Your Pride Lift Chair is equipped with a low voltage DC electrical system that reduces the standard household alternating current of 100V AC - 240V AC to direct cur- rent (24/39V DC). The electrical components include the external transformer, batteries (not included) and hand control.
Page 11
Refer to “Appendix B” for a mounting diagram. NOTE: Pride is not responsible for damage due to improper installation. Batteries: Provide the power needed to return the lift chair to an upright or semi-upright position in the event of a power failure.
LIFT CHAIR SERIES IV. ASSEMBLY/DISASSEMBLY LIFT CHAIR ASSEMBLY Your lift chair will be shipped in two pieces: the chair-back and chair base. Minor assembly is required before initial use. Follow the instruc- tions below for proper lift chair assembly. Tools Required: 11-mm spanner (1) Follow these steps to assemble the lift chair: 1.
Your lift chair should be placed near a standard electrical outlet on dry, level ground where there is ample room to allow for proper operation. Pride recommends that you have the assistance of an attendant when positioning the lift chair to avoid the possibility of injury when lifting.
LIFT CHAIR SERIES IV. ASSEMBLY/DISASSEMBLY REMOVABLE CHAISE PAD DISASSEMBLY The chaise pad attaches to the lift chair with reus- able fasteners to make servicing the chair more convenient. NOTE: The lift chair must be in the recline posi- tion in order to remove or attach the chaise pad. To remove the chaise pad, loosen the front portion of the footrest and remove the chaise pad from the lift chair (Fig.
LIFT CHAIR SERIES V. OPERATION OPERATION PRECAUTIONS There are certain precautions that should be taken during the operation of your lift chair. Read and follow these precautions carefully in order to ensure safe lift chair operation and to prevent injury and/or product damage.
Page 16
Figure 5.1 Hand Control If this LED is not lit when the hand control is in use, contact your authorised Pride Dealer. Follow these steps to raise or lower the footrest while in the seated or reclined position (Fig. 5.1): 1.
Page 17
NOTE: As an added safety measure, Pride recommends that you utilise the quick disconnect to remove the hand control from the lift chair and store the hand control out of the reach of children when the chair is left unattended.
If at any time you do not feel comfortable performing the troubleshoot- ing steps listed in this manual, contact your authorised Pride Dealer for service. Please have the model number, serial number and nature of the problem when calling.
Your lift chair must be disposed of according to applicable local and national statutory regulations. Contact your local waste disposal agency or authorised Pride Dealer for information on proper disposal of lift chair packaging, metal frame components, fabric, electronic components and batteries.
VIII. WARRANTY TWO-YEAR LIMITED WARRANTY For two (2) years from the date of purchase, Pride will repair or replace at our option to the original purchaser any of the following parts found upon examination by an authorised representative of Pride to be defective in material and/or workmanship:...
Page 21
LIFT CHAIR SERIES NOTES Lift Chair Series www.pridemobility.com...
APPENDIX A LIFT CHAIR WEIGHT CAPACITY Model Number Rated Weight Capacity 170 kg (27 stone/375 lbs.) MANDATORY! Stay within the specified weight capacity of your lift chair. Exceeding the weight capacity voids your Pride Lift Chair warranty. www.pridemobility.com Lift Chair Series...
Page 23
LIFT CHAIR SERIES APPENDIX B EXTERNAL TRANSFORMER OPTIONAL WALL MOUNT DIAGRAM Cut out this diagram (1:1 scale) and use to mark area of placement for the external transformer. Lift Chair Series www.pridemobility.com...