Pride C1 Owner's Manual page 13

IV. ASSEMBLY/DISASSEMBLY
NOTE: Depending on chair width, you may need to slide on one side of the chair-back at a time. If this
is the case, level the chair-back before pressing down to lock into position.
4.1.3 Push firmly on the top of the chair-back to
lock into position. Listen for a click on each
side to ensure the chair-back is locked in
properly.
NOTE: Pull up on the chair-back to ensure that it
is locked in place. If the back can be pulled off,
then repeat steps 4.1.1 through 4.1.3.
HEAT CONNECTION TO JUNCTION BOX
JUNCTION BOX
4.1.5 Connect the heat and massage harnesses to
the junction box. The junction box is mounted
to the back of the lift chair. Refer to "Appendix
D" for proper harness connections.
Lift Chair Series
"CLICK"
4.1.4
MASSAGE UNIT
4.1.6
www.pridemobility.com
For C6 Lift Chairs, tuck the fabric flaps on the
front of the chair-back and rear of the chair
base down into the frame and secure with the
reusable fastener on each flap. Then, zip the
two sections together.
Attach the chair-back to the hook and loop
flaps on the bottom of the chair base.
LIFT CHAIR SERIES
13