Onkyo TX-NR901 Service Manual page 4

SERVICE PROCEDURES 2
Specifying the AM Frequency Step
(Worldwide model only)
This section explains ho w to specify the AM frequenc y
step. (This setting is not available on American and Aus-
tralian models.)
1
Press the scroll wheel, and then
press the [SETUP] button.
The main menu appears onscreen.
2
Use the Up/Down [
tons to select "0. Hardware
Setup," and then press the
ENTER
[ENTER] button.
The Hardware Setup menu appears.
ENTER
3
Use the Up/Down [
tons to select "5. AM Frequency
Step," and then press the
ENTER
[ENTER] button.
The AM Frequenc y Step menu appears.
0-5.AM Frequency Step
a.Frequency Step
ENTER
Quit:[SETUP]
4
Use the Up/Down [
tons to select "a. Frequency
Step," and then use the Left/Right
ENTER
[ ]/[ ] buttons to select:
10 kHz: Select if 10 kHz steps are
used in your area.
9 kHz: Select if 9 kHz steps are used
in your area.
5 Press the [SETUP] button.
The setup menu closes.
Note:
* This procedure can also be performed by using the
TX-NR901's [SETUP] button, [ ]/[
buttons, and [ENTER] button.
]/[ ] but-
]/[ ] but-
:9 kHz
]/[ ] but-
]/[ ]/[ ]
TX-NR901