3 ] Removing The Power Supply Assy And Main Pcb Assy - Brother P-Touch QL-570 Service Manual

[ 3 ] Removing the Power Supply ASSY and Main PCB ASSY
(1) Turn the main body upside down.
(2) Remove the four screws, and then remove the lower plate ASSY.
Fig.3.1-7 Removing the Power Supply ASSY and Main PCB ASSY (1)
(3) Remove the two screws, and then remove the power supply ASSY.
Note: At this point, the harness is still attached, and therefore the power supply ASSY
cannot be removed yet.
Power supply ASSY
Sub ASSY inlet harness
Fig.3.1-8 Removing the Power Supply ASSY and Main PCB ASSY (2)
Screws
Screws
III- 8
Screws
Lower plate ASSY
Main body
Under cover