Table of Contents
Advertisement
Mounting the Access Point
Wall Mounting the Access Point
The optional PMK contains a mounting bracket for wall mounting or pole mounting. You can use the
mounting bracket as a template to mark the positions of the mounting holes for your installation. You
then install the mounting plate, and attach the access point when you are ready.
materials you will need in addition to the mounting kit.
Table 2-1
Materials Required to Mount Access Point to a Vertical Wall In Kit
Ground lug and screws (provided with access point)
Wall Mount Bracket
Four M6 x 12-mm Hex-head Bolts
Two stainless steel band clamps (adjustable 2"–5", 51 mm –
127 mm)
Two stainless steel band clamps(adjustable 5"–8", 127 mm –
203 mm)
Crimping tool for ground lug, Panduit CT-720 with CD-720-1
die
Four wall mounting screws
Four wall anchors (specified for all material)
Drill bit for wall anchors
Electric drill and standard screwdriver
#6 AWG ground wire
Shielded outdoor-rated Ethernet (CAT5e or better) cable
Grounding block
Grounding rod
10-mm box-end wrench or socket set
Caution
To mount the access point on a vertical wall, follow these instructions:
Use the mounting bracket as a template to mark four screw hole locations on the mounting surface.
Step 1
See
the unit to the wall.
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
2-14
Materials Required to Mount Access Point to a Vertical Wall
(http://www.panduit.com)
The mounting surface, attaching screws and optional wall anchors must be able to support a
50-lb (22.7 kg) static weight.
Figure 2-8
for the mounting bracket screw hole locations. Use the mounting slotted holes to attach
Chapter 2
Installing the Access Point
Table 2-1
Yes
Yes
Yes
Yes
Yes
No
No
No
No
No
No
No
No
No
No
lists the
OL-32138-01
Advertisement
Table of Contents
