Cisco AIR-AP1572IC Hardware Installation Manual page 66

Powering the Access Point
Figure 2-22
1
DC power opening in access point case. Also
see
Figure 2-23
Slide the cable gland with the rubber seal towards the access point, and screw the threaded end of the
Step 9
body into the access point, and hand-tighten.
Step 10 Use an adjustable wrench, a 28-mm wrench to tighten the threaded end of the body to 15 lb-in.
Use an adjustable wrench and tighten the thread-lock seal nut to 15 lb-in.
Step 11
Ensure that the antennas are connected to the access point before you apply power to the access point.
Step 12
Turn on the DC power at the designated circuits.
Step 13
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
2-36
Inserting the Terminal Strip into the DC Power Opening in the Access Point Case
Figure 2-23.
DC Power Opening in the Access Point Case
Chapter 2
2
Exploded view of the cable gland on the DC
power cable
Installing the Access Point
1
2
OL-32138-01