Installing The Front Bezel And End Caps - Bosch DSA-N2E8X4-12AT Quick Installation Manual

DSA E-Series (E2800 12-bay)
6.
7.
Notice!
Install the expansion units below and above the controller unit, keeping the weight in the
lower portion of the cabinet.
4.2

Installing the front bezel and end caps

A front bezel covers the front of the controller unit and the expansion unit, while left and right
end caps cover the mounting flanges on each unit.
To install the front bezel:
1.
2.
To install the end caps:
1.
2.
3.
Bosch Sicherheitssysteme GmbH
Secure the unit to the back of the rails by inserting two M5 screws through the brackets
at the unit and the rail kit bracket.
If applicable, replace the end caps or the system bezel.
Note: Additional documentation can be found on the Bosch online catalog.
Position the front bezel in front of the controller unit or the expansion unit so that the
holes at each end align with the fasteners on the unit.
Snap the bezel into place.
Position the left end cap in front of the controller unit or the expansion unit so that the
holes in the end cap align with the fasteners on the left side of the unit.
Snap the end cap into place.
Repeat these steps for the right end cap.
Quick Installation Guide
Installation | en 15
2017.12 | V1 | DOC