Advertisement
OPERATION
Plug the mains lead into a 13Amp socket and switch the product on at the mains. Using the two power
switches on the side of the product select the required operation.
1. Make sure the selector switch is switched to position I see (Timer section below) for manually on
2. Both switches off = Off
3. Left switch on right switch off = Low heat
4. Left switch off right switch on = Medium heat
5. Both switches on= High Heat
This product is also fitted with an adjustable thermostat. After selecting the required heating setting turn
the thermostat clockwise until it reaches its furthest point. Allow the room to heat up to the required
temperature and then rotate the thermostat anti-clockwise until you hear the heater click off. Leaving
the thermostat in this position will maintain the temperature at this level.
Please note that in very large room or draughty rooms the product might be insufficient to reach the
required temperature.
HEATER MODE BUTTON
0 = Off (this will switch the heater off even when not being used with the timer.
Clock= Timer Mode
I = On manual
TIMER INSTRUCTIONS
1) Set the mode button to timer
2) Set the time by rotating the outer dial until the current time is in line with the pointer arrow
3).The timer is controlled by moving the plastic segments in and out from the centre. Each segment
is equal to 15 minutes. Moving the segment out (away from the centre) will switch the unit on and
towards the centre will turn the product off
3
Advertisement
