Settings - Electrolux ESL4500LO User Manual

8 www.electrolux.com
5.1 Consumption values
Programme
P1
P2
P3
P4
P5
1) The pressure and the temperature of the water, the variations of the mains supply, the
options and the quantity of dishes can change the values.
5.2 Information for test
institutes
For all the necessary information for test
performance, send an email to:

6. SETTINGS

6.1 Programme selection mode
and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener
according to the water hardness.
• The activation or the deactivation of
the acoustic signal for end of
programme.
• The activation or deactivation of the
rinse aid dispenser when you want to
use the Multitab option without rinse
aid.
These settings will be saved until you
change them again.
Water
1)
(l)
9.9
6 - 11
11 - 13
8
4
Energy
(kWh)
0.789
0.5 - 1.2
1.0 - 1.2
0.8
0.1
info.test@dishwasher-production.com
Write down the product number (PNC)
that is on the rating plate.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
When you activate the appliance, usually
it is in programme selection mode.
However, if this does not happen, you
can set the programme selection mode
in the following way:
Press and hold Reset until the appliance
is in programme selection mode.
6.2 The water softener
The water softener removes minerals
from the water supply, which would have
a detrimental effect on the washing
results and on the appliance.
Duration
(min)
225
40 - 140
130 - 150
30
14