Contents Safety Instructions...............................3 Optical Expansion Link............................4 Unpacking..................................4 Getting Started - Installing the Cards......................6 Inserting and Removing Cables........................8 Creating the Link - “x8” ..............................9 Creating the Link - “x4” ..............................9 Frame Locking................................10 Specification..................................11 Datapath Limited...............................12 Index ....................................13...
To prevent damage to your Datapath product or injury to personnel operating the ento el equipo, a fin de evitar daños en su producto de Datapath o lesiones al personal equipment, please read the following safety precautions prior to operation. These encargado de su manejo.
Optical Expansion Link The Datapath PCI Express Optical Expansion Link is a solution that allows system builders and integrators to extend a PCIe based PC or motherboard to multiple expansion chassis. Enabling greater flexibility and larger distributed system architecture, the PCI Express Optical Expansion Link can be used to create systems with distances of up to 100m between the host PC and expansion chassis.
Remove the PC cover • Locate a vacant PCIe (x4 or above) slot for the HLink-Optical card in the host machine and a PICMG 1.3 compliant slot in the expansion chassis for the SLink-Optical card. Remove the backing plates (retain all screws).
Inserting and Removing Cables The ExCables-Optical should be inserted firmly into the connector on the HLink and SLink- Optical cards. Fig. 6 The correct way to insert the cable is to have the manufacturers label facing the card as shown in Fig. 6. Fig.
ExCable-Optical link the PCIe connection is “x4” and the bandwidth is reduced to 3.2GB/s. In “x4” mode the Jumper Link “J7” must be set to position 1-2 as shown in Fig.11. Either (or both) connectors on the HLink-Optical card can be used, but only the top connector of the SLink-Optical card (see Fig.12).
Fig. 12 - x4 Link Frame Locking When using the Datapath Optical Expansion Link it is not possible to maintain display frame locking. It is assumed that displays controlled from the expansion chassis would be sufficiently far away from the host machine that this will not be a problem.
As more sophisticated equipment and techniques become readily available, so we are there to exploit the power and potential that this technology presents. Technical Support Registered Users can access our technical support line using, email, and the Support page on the Datapath Web Site, usually with a response within 24 hours (excluding weekends). Via Email Send an email to support@datapath.co.uk with as much information about your system as possible.