Product Specifications - Cisco 5915 Technical Manual

Product Specifications

For integrators planning to use the conduction-cooled Cisco 5915 ESR, mounting holes are in the
thermal plate. These mounting holes are used to hold an I/O board or flex circuit to the Cisco 5915 ESR.
The mounting hole size is 0.125 Inches (diameter). Four 4-40 pan head screws are required.
For integrators planning to use the air cooled Cisco 5915 ESR, mounting holes are provided in the
Printed Circuit Board (PCB) which can be used, along with a custom "L bracket" to hold an I/O board
or flex circuit to the Cisco 5915 ESR.
Note
Mounting hole and screw sizes for air cooled Cisco 5915 ESR depend on the system or environment in
which the air-cooled cards are used.
Note
When you connect routed ports of the Cisco 5915 ESR to routed ports on a neighboring device and
autonegotiation is disabled on both sides of the connection, a crossover cable may be necessary
(depending on the capabilities of the neighboring device). If autonegotiation is enabled, any type of cable
connection can be used.
Product Specifications
Table 7
Table 7
Cisco 5915 ESR Feature
Hardware Encryption
Memory
DRAM
Flash Memory
Interface Support
Fast Ethernet
Router Console Port
Environmental
Industrial-grade components
Cisco 5915 Embedded Services Router Hardware Technical Guide
12
lists the technical specifications for Cisco 5915 ESR.
Cisco 5915 ESR Product Specifications
Feature Description
•
Onboard hardware encryption processor supporting IP Security
(IPsec)
•
Secure Sockets Layer with transparent LAN services
(SSL/TLS)
•
Triple Digital Encryption Standard (3DES)
•
Advanced Encryption Standard (AES)
•
Internet Key Exchange (IKE)
•
Message Digest - MD5 & SHA along with HMAC
512 MB
256 MB
Two routed 10/100 copper ethernet ports
Three switched 10/100 copper ethernet ports
One RS-232 console port supporting modem flow control signaling.
–40° F to +185° F (–40° C to +85°C) component local ambient
temperature ranges
OL-24796-01