Controls; Front Panel Controls - MartinLogan Crescendo X User Manual

c
ontrols

FRONT PANEL CONTROLS

STANDBY/MUTE: This button mutes the speak-
er and toggles between on and standby. To
mute press the button once (front LED will flash red). To
enter standby press the button for two seconds (front LED
will turn red). If no audio signal is detected for ten min-
utes, the speaker will automatically go into networked
standby mode (Wi-Fi and Ethernet remain active).
When the speaker is in standby mode, press the button
once to exit. A new audio signal will also automatically
wake the speaker. Please note, if the Auxiliary Input
has a cable plugged into the connection (with or with-
out active audio content), the speaker will not go into
standby mode automatically and will not stay in standby
mode, even if manually activated (fig. 2).
INPUT: Cycles through the audio inputs.
The order of the inputs is:
Fig. 2 Front Panel Controls
STANDBY/MUTE
Wireless/Ethernet (purple) > Auxiliary (green) >
Bluetooth (blue) (fig. 2).
FRONT LED: The LED on front of the speaker indi-
cates the following (fig. 2):
• No Color: Speaker does not have power (or
• Red: Speaker is in standby.
• Flashing Red: Speaker is muted.
• Purple: Wireless/Ethernet input active.
• Flashing Purple: Wireless/Ethernet input active
• Green: Auxiliary input active.
• Blue: Bluetooth input active.
the section titled "VOLUME BEHAVIOR BY INPUT."
INPUT FRONT LED
updating firmware).
(no network connected).
VOL –/VOL +: Adjusts the volume
level (fig. 2). For more details see
VOL– VOL+
11